Hatching for 3D Prints: Line-Based Halftoning for Dual Extrusion Fused Deposition Modeling

05/03/2018 ∙ by Tim Kuipers, et al. ∙ 0

This work presents a halftoning technique to manufacture 3D objects with the appearance of continuous grayscale imagery for Fused Deposition Modeling (FDM) printers. While droplet-based dithering is a common halftoning technique, this is not applicable to FDM printing, since FDM builds up objects by extruding material in semi-continuous paths. The line-based halftoning principle called `hatching` is applied to the line patterns naturally occuring in FDM prints, which are built up in a layer-by-layer fashion. The proposed halftoning technique isn`t limited by the challenges existing techniques face; existing FDM coloring techniques greatly influence the surface geometry and deteriorate with surface slopes deviating from vertical or greatly influence the basic parameters of the printing process and thereby the structural properties of the resulting product. Furthermore, the proposed technique has little effect on printing time. Experiments on a dual-nozzle FDM printer show promising results. Future work is required to calibrate the perceived tone.

READ FULL TEXT
POST COMMENT

Comments

There are no comments yet.

Authors

page 2

page 4

page 5

page 8

page 9

page 10

This week in AI

Get the week's most popular data science and artificial intelligence research sent straight to your inbox every Saturday.